Running De-Frag/X in Batch

Included with De-Frag/X is a jobstream (JDEFRAGX.DEFRAGX.LPS) which can be used to run De-Frag/X in batch mode. This jobstream is set up to perform a MAP command on each ldev before and after an execution of the TRIM command on all files and the CONDENSE commands on all drives. You should modify this jobstream to reflect the particular drives on your system that you wish to MAP and/or CONDENSE.

The following sequence of commands demonstrates the JDEFRAGX jobstream:

!job jdefragx,manager.sys; outclass=,1

!

!tellop Starting JDEFRAGX...

!

!showtime

!run defragx.defragx.lps

set permyes

set log

reset fscheck

analyze

map all

map each

trim @.@.@

cond all

map all

map each

exit

!

!showtime

!tellop ...JDEFRAGX all done!

!

!eoj